Instruction Manual
10
5.4 NiMH/NiCd Battery Program
5.4.1 After check all the mode to start the process press
“ENTER/START“ key for more than 2 seconds
5.5 Pb battery program
5.5.1 Charging Pb Battery
Press “MODE/ESC“ key to the screen on the left, then press “ENTER/START“ to enter the
submenu. You can switch at the same level menu to select the mode by ◄ DEC/INC ► key.
Please refer the etailed flow chart on the left. When you are willing to alter the parameter
value in the program, press “ENTER/START“ key to make it blink, then change the value with
◄ DEC/INC ► key. The value will be stored by pressing “ENTER/START“ key once. Then press
“ENTER/START“ key for more than 2 seconds to start the process. Since the menu of NiMH are
the same as NiCd, there is an example of NiMH only.
“CHARGE“ mode the default mode is “AUT“. In “AUT“ mode, you need to set the upper limit
of charge current to avoid from higher feeding current that may damage the battery. Because
some batteries of low impedance and small capacity can lead to the higher charge current by
the processor at automatic charge mode. But in “MAN“ mode, it will charge the battery with
the charge current you set at the display. Each mode can be switched by pressing “ENTER/
START“ key, when the current field is blinking, press ◄ DEC/INC ► key for more than
1 second.
“DISCHARGE“ mode the discharge current ranges from 0.1 A to 5.0 A and the final voltage
ranges from 0.1 to 25.0 V, the operating method is similar as Lithium battery. The final
voltage of NiMH battery is 1.0 V/cell, and the NiCd is 0.85 V/cell, please refer the recommend
by the battery of manufacturer.
“CYCLE“ mode xMove 2.0 Ultimate can perform 1-5 cycles of DCHG>CHG or CHG>DCHG con-
tinually. You can select it for the new NI** battery or the long-term placement NI** battery.
PLEASE SET UP CAREFULLY, OR IT WILL DAMAGE THE BATTERY!
To set the parameter
please follow the previous charge/discharge menu.
The screen displays the present state of process. To stop it press “MODE/ESC“ key;
Description:
: the type of battery; : operating mode, CHG = charge · DSC = discharge
· DCHG > CHG or CHG > DCHG = the cycle mode; : elapsed time; : charge/discharge
current of the battery; : voltage of the battery pack; : capacity of charge/discharge.
You can inquire the temperature and ∆V continually by press ◄ DEC/INC ► key.
This is programmed for charging Pb battery with nominal voltage
from 2 to 24 V, Pb battery can not be charged rapidly. They can only
deliver relatively lower current compare to their capacity.
The optimal charge current will be 1/10 of the capacity. Please
always follow the instruction supplied by the manufacturer of battery.
As you can see on left, you can set up the charge current on the left. The nominal of the
second line and voltage of the battery on the right of the second line. The charge current
ranges from 0.1–10.0 A and the voltage should be matched with the battery being charged.
Start the charge process by pressing “ENTER/START“ key for more than 2 seconds.
The screen displays the state of charging process. To stop charging forcibly, press “MODE/ESC“
key once.
1
5
6
2
3
4
