Anslut 411105, Руководство по эксплуатации

Страница: 26 / 27

EN
26
valve is defective.
3. Contact an authorised service centre.
USE
LIGHTING
1. Open the valve on the gas cylinder completely.
2. Lightly press and turn the knob to the
PILOT position (90°
anticlockwise).
3. Keep the knob pressed for 30 seconds. Press the IGNITER
button several times until the pilot flame lights.
4. Release the knob.
5. Repeat step 3 if the pilot flame goes out or does not light.
6. When the pilot flame lights, turn the knob to the highest
position and wait for 5 minutes. Now turn the knob to the
required temperature.
FIG. 10
NOTE:
•
When a new gas cylinder has been connected, wait at
least a minute so that the air in the gas line has time to
pass out through the pilot hole.
• Keep the knob pressed down when you press the ignition
button to ignite the pilot flame. Release the knob when
the pilot flame lights.
• At the bottom of the flame screen, next to the regulator,
there is a round sliding hatch through which the pilot
flame can be controlled and adjusted.
SWITCHING OFF
1. Turn the knob to the PILOT position.
2. Lightly press and turn the knob to the OFF position.
3. Close the valve on the gas cylinder completely.
MAINTENANCE
• Inspect the gas hoses at least once a month, when replacing
the cylinder, and before putting the gas heater away or
starting to use it after it has been stored. Replace gas hoses
with new ones of the same quality and length if they are
damaged.
• Check the entire gas system (gas hoses, gas regulator, pilot
flame, burner, etc.) for damage and leakage before each
use. The entire system should be inspected by qualified
personnel at least once a year.
• Repairs must be carried out by an authorised service centre.
• Clean painted surfaces with a soft, damp cloth.
• Do not use flammable or corrosive detergents.
• Keep the burner clean to avoid danger.
• Cover the burner when the heater is not in use.
STORAGE
• Immediately turn off the valve on the gas cylinder completely
after use as well as in the event of any interference.
• Remove the pressure regulator and gas hose.
• Make sure the gas valve is tight and free of damage. Contact
your gas dealer if you suspect that the valve might be
damaged.
• Never store gas cylinders in a basement or in rooms with
inadequate ventilation.
WARNING!
•
Never store gas cylinders in a basement or in rooms with
inadequate ventilation.
• Never store gas cylinders near the gas heater, except for
the cylinder that is connected to the heater.
• The storage of gas cylinders must comply with local
regulations.