Anslut 014274, Руководство по эксплуатации

Страница: 19 / 20

EN
19
height. Tighten the height adjustment
ring.
FIG. 6
NOTE:
The inner column tube can be concealed in
the extension tube. In which case, pull out
the extension tube to the required height.
5. Undo the wing screw on the bottom of
the motor unit to fit the motor unit on the
column tube. Put the motor unit on the
inner column tube and tighten the wing
screw so that it engages with a suitable
slot in the inner column tube.
FIG. 7
FITTING THE FAN BLADE AND
GRILLE
1. Unscrew the hub nut clockwise and the
plastic nut anticlockwise. Fit the back grille
on the motor unit and tighten the plastic
nut.
FIG. 8
2. Put the fan blade on the axle and check
that the pin on the blade axle engages in
the slot in the fan blade. Turn the hub nut
anticlockwise to lock to lock the fan blade.
FIG. 9
3. Put the front and back grille together with
the grille clamp and tighten the lock screw
and nut for the grille.
USE
1. Set the required speed with the power
switch:
– 0: Off
– 1: Low speed
– 2: Medium speed
– 3: High speed
2. To activate/deactivate oscillation, pull up/
press down the oscillation button.
3. Carefully press the grille to adjust the air
flow in the vertical plane.
4. Adjust the height setting by releasing
the height adjustment ring and carefully
lifting or lowering to the required
height, and then tightening the height
adjustment ring again.
MAINTENANCE
NOTE:
Pull out the plug from the power point before
installation and/or cleaning.
The product should be cleaned once a month.
Clean the fan with a soft cloth moistened with
a mild detergent. Make sure that no water or
other liquid gets into the fan.
NOTE:
Do not use petrol, solvents or detergents that
can damage the plastic parts.