Anslut 004840, Руководство по эксплуатации

Страница: 19 / 20

EN
19
Adjusting the speed
Adjust the speed by pressing SPEED on the remote
control or control panel. The corresponding status
light on the top of the fan goes on.
Oscillation mode
Enable/disable oscillation mode by pressing
OSC on the remote control or the control
panel. The corresponding status light on the
top of the fan goes on.
Timer function
Enable/disable the timer function by pressing
TIMER on the remote control or the control
panel. Press to change the set time from 0.5
to 7.5 hours in steps of 0.5. The corresponding
status light on the top of the fan goes on.
Normal mode/sleep mode
1. Press MODE once to enable normal mode.
In this mode the fan speed increases or
reduces automatically.
2. Press MODE again to enable sleep mode.
In this mode the fan speed is reduced.
Press MODE again to return to normal
mode. The corresponding status light on
the top of the fan goes on.
MAINTENANCE
NOTE:
Pull out the plug before installation and/or
cleaning.
• Clean the fan with a soft cloth moistened
with a mild detergent. Make sure that no
water or other liquid gets into the fan.
• Do not use petrol, solvents or detergents
that can damage the plastic parts.
Replacing the battery
1. Press in the catch and open the battery
flap.
FIG. 4
2. Insert the battery with positive terminal up.
Only use batteries of the recommended
type (CR2025).
3. Push in the battery flap on the remote
control.
FIG. 5