Anritsu MX371054A, Руководство по эксплуатации

Страница: 18 / 24

Chapter 2 How to Use Waveform Patterns
2-4
2.1.3 Loading to waveform memory
To output a modulated signal using this waveform pattern, it is
necessary to load the waveform pattern that was transferred to the
internal hard disk of the MG3710A/MG3710E (described in 2.1.2
“Transferring waveform pattern to internal hard disk”) to the waveform
memory. A waveform pattern can be loaded into the waveform memory in
the following two ways.
■ Configuring using the MG3710A/MG3710E
A waveform pattern can be loaded into the waveform memory by using
the instruction panel of the MG3710A/MG3710E or by using a remote
command.
For operation using the front panel, refer below:
●
MG3710A/MG3710E Operation Manual
7.3.4 “Loading waveform pattern: Load”
For operation using remote commands, refer below:
●
MG3710A/MG3710E Operation Manual
7.3.4 “Loading waveform pattern: Load”
■ Using Transfer & Setting Panel of IQproducer™
A waveform pattern can be loaded from the LAN-connected PC to the
memory by using Transfer & Setting Panel, which can be opened from
the Simulation & Utility tab. For details, refer to 4.6 “File Transfer and
Loading to Memory in Transfer & Setting Panel Screen” in the
MG3710A/MG3710E IQproducer™.