3-8
PN: 10410-00742 Rev. H
O/E Module MN4765B OM
3-3 O/E Measurements
Operation
Required Equipment
Refer to the required E/O measurements equipment listed in
Section “Required Equipment” on page 3-2
.
Measurement Steps
1.
Perform a 12-term calibration on the VNA over the frequency range of
interest. Save the calibration for later recall.
2.
For VectorStar VNAs, press the
Measurement
menu button on the VNA
front panel. Select the
Perform Optical Measurements
button, then
select
O/E Measurements
.
For ShockLine VNAs, from the
Measurement
menu, select the
O/E-E/O
button. From the
O/E-E/O
menu, select
O/E
Measurements
.
3.
Follow the instructions in the dialog shown in
to load the
12-term electrical calibration that was saved in Step 1.
Figure 3-5.
O/E Measurement Dialog
VNA
