15
15.Confirm Accuracy by Comparison
Step 1: Prepare Source and Targets
Prepare the source HDD and target HDDs to compare after duplication is completed.
Step 2: Place Source and Targets
Place the source HDD to source port, target HDDs to rest of the ports.
Step 3: Enter "2.Compare"
Use UP DOWN to select “2.Compare” then press <OK>. Data compare will proceed.
Caution
User is responsible for verification of targets’ quality. Testing a few completed targets in a
mass production environment for quality control is recommended.
16.Data Sanitization
Caution
1.It will erase the data in HDD, please make sure you backup all important data before using
this function.
2.To cancel operation of any erasing mode, press <ESC> key and hold continuously for 3
seconds to exit any erasing tasks.
Step 1: Prepare HDDs
Prepare HDDs for disposal.
Step 2: Place HDDs
Insert HDDs for disposal into target ports.
Note
Source Port is disabled for erasing. Go to “6.6.2 Erase Master” to enable source port erasing.
Note
It is recommended to execute Compare and Copy to confirm the accuracy.
