Anolis ArcPower 144, Руководство пользователя

Страница: 7 / 20

6 7
5. Installing instructions
5.1 DMX operating
1. Unplug from the mains before installation.
2. Connect the LED modules to the fixture.
3. Connect DMX controller to the fixture.
4. Connect the fixture to the mains.
5. Set the DMX address on the control board of the fixture (see chapter "Control board").
Warning! Accidental connection DMX 512 Input/Output to non-DMX 512 device
(e.g.Ethernet network Hub) can demage the ArcPower 144.
Maximum total cable length between one LED zone output of the Arcpower
144 and all its connected LED modules is 80 metres.
Single ArcPower 144 installation:
Multiple ArcPower 144 installation:
Connect the DMX output of
the first ArcPower 144 with
the DMX input of the next
ArcPower 144. Always con-
nect one output with the
input of the next ArcPower
144 until all fixtures are
connected. In this way, up
to 32 fixtures can be chained
together.
At the last ArcPower 144
the data link has to be ter-
minated with a terminator. A
termination plug is simply a
RJ45 connector with a 120
Ω
resistor between pins Data
(–) and Data (+). Plug ter-
minator in the DMX output of
the last ArcPower 144.
Maximum number of LEDs
connected to the one
ArcPower 144 zone is 42,
(but maximum 12 LEDs per
colour).