WARNING:
Risk of electric shock – This pump is supplied with a grounding
conductor and grounding type attachment plug. To reduce risk of
electric shock, be certain that it is connected only to properly
grounded, grounding-type receptacle
To reduce the risk of electrical shock, use only on portable self-
contained fountains no larger than 5 ft in any dimension.
Risk of Electric shock. Do not remove cord and strain relief. Do not
connect conduit to pump.
This pump has been evaluated for use with water only.
Reduce risk of electric shock during operation of this pump requires
the provision of acceptable grounding
Risk of electric shock – This pump has not been investigated for use
in swimming pool or marine areas.
Do not connect to any voltage other that that shown on the pump
Always disconnect from electrical supply before handling pump.
Don’t operate without water
Operate pump completely submerged for proper cooling
DISPOSAL: Do not dispose this product as unsorted municipal waste.
Collection of such waste separately for special treatment is necessary.
Used as submersible pumps
IMPORTANT: Do not let the pump run dry – this could cause damage to the
motor.
Submerse the pump completely so as to make the pump body fill with
water.
A water level of approx. 6 in. is required for submersible use in order to
prevent the pump from taking in air.
To prevent the filter becoming prematurely clogged, do not place the
pump in the mud.
The pump is designed to accommodate 1” internal threads as well as 1”
external threads through the socket (fountain jets, nozzles, water height
regulators, standpipes, etc.).
Running in conjunction with fountain jets, the pump should be stationed
firmly and horizontally (on a brick)
The pump can be switched on by simply plugging it in and switched off
by un-plugging it.
The water temperature should not exceed 95°F (35°C) and do not let the
pump freeze in the wintertime.
This appliance is not intended for use by persons, (including children)
with reduced physical sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Safety Instructions
Read and observe all the instruction supplied with the
appliance and on the appliance
Make sure that your outlet voltage corresponds to those stated
on the rating label of the pump(s).
Make sure the appliance is securely installed before operating
it.
The electrical connection should be located in a water-proof
area and should be at least 6 feet away from the edge of the
pond. (see fig. 1)
Keep the electrical connections dry! Ensure that the electrical
cord loop below the electrical outlet to form a “Drip Loop”. This
will prevent water from running down the cord into the
electrical outlet
Always unplug the appliance when not in use, before putting
on or taking off parts, before cleaning the pump and before
doing any work for the fountain or pond.
The pump must not be used when people are working in
water. Please disconnect the pump first.
Do not operate any appliance with a damaged cord or plug, or
in abnormal state. The supply cord of the appliance cannot be
replaced.
If the cord is damaged the appliance should be
scrapped.
For safety reasons, any repair work should be done only by
the manufacturer of the products or the authorized service
facility or discard it
Never hang or transport the pump by means of pulling the
power cord!
Close supervision is necessary when the appliance is used by
or near children.
If you want to disconnect the pump, you can pull out the plug
and the plug must be placed where you can access it.
Never use any accessories which are not recommended by
the appliance manufacturer. It may result in fire, electric shock,
personal injury and/or voided warranty.
The pump is to be supplied through a residual current device
(RCD) with a rated residual operating current not exceeding
30mA.
Min Length of power cord is 30ft.
To protect against the risk of electrical shock, do not immerse
the plug in water or other liquid.
