Anita Garudan GIF-2500, Руководство пользователя

Страница: 20 / 89

© ANITA
MP03400EN_181010 20
6. The relation between needle and real needle guard:
6.1 Setting the height of rear needle bar:
When needles descend to the lowest position. The ridge line (A) of rear needle guard (B) align with
the center of the eye of each needle. The adjustment of the height of rear needle guard is made by
loosening the screw (Fig. I).
6.2 Setting the angle and timing of rear needle guard:
When the tip of looper passes the center of right needle. The rear needle guard will slightly push the
right needle forward about 0.2-0.3 mm. And at this time, the clearance between looper and right
needle is 0-0.05 mm and looper will touch middle needle slightly and the clearance between looper
and left needle is 0-0.05 mm. These adjustments are made by loosening the set screws (C) and (D),
(Fig. J, K).
Fig. I Fig. J Fig. K
7. The relation between needle and front needle guard:
7.1 Setting the angle and timing of front needle guard:
When the tip of looper comes to the center of left needle and right needle, adjust the clearances
between those needles and front needle guard should be 0 - 0.3 mm. The adjustments are made by
loosening set screw (E) and move front needle guard to its proper position. Then, tighten the set
screw (E), (Fig A).
Fig. A
www.garudan.cz