5
Wiring
Wire the main unit (gun) and AC adapter according to the connection diagram as shown below.
This product, SER-24PA, consists of an electrostatic eliminator, an AC adapter, and a wave motion air nozzle. Wave motion air nozzle and AC adapter are not connected.
Connect as shown above by the customer before use.
The wave motion air nozzle is a 1/8 male screw type. Tighten firmly with a wrench (14 mm). If the tightening is insufficient, the nozzle may loosen due to the
vibration of the wave motion air nozzle, which is dangerous if it comes off.
Connect the power input cable of the main unit (gun) to the AC adapter.
Connect the AC adapter to a power outlet (AC100V to 240V 50/60Hz).
Piping
Connect the main unit according to the connection diagram as shown above.
Attach an air tube (O.D. 6mm) to the air fitting (push-in fitting) at the bottom of the gun and connect it to the air equipment (air compressor, blower).
Use clean air (air that does not contain water or oil).
電源入力ケーブル（3m）
ACアダプタ
AC100V〜240Vへ
エアー入力（φ6）
エアチューブ（φ6）
本体
エア源へ
Air inlet
Power input cable (3M)
Main Gun body
Air tube
AC Adapter
To air source