－ ７ －
●
Spraying
Important
Filter color material with fine filter paper (cloth), or pigments may clog nozzle.
* When spraying lacquer or varnish, add retarder to prevent whitening.
* Never damage nozzle cap or nozzle. If done, it will adversely affect atomization.
* Do not mix different color material (example: paint and dyestuff).
If done, the viscosity will increase and cause malfunction.
1)
How to hold
2
）
Operation
■
Maintenance after Painting
●
Maintenance
WARNING
* Always completely release pressure before maintenance in accordance with warning of safe operation on page
2. If not done, remaining pressure can cause injury by the splashing of cleaning liquid or other misuse.
* The operator must be fully conversant with the requirements in this manual and have sufficient
knowledge and experience.
* Pay full attention to the sharp tip of needle in order to avoid injury.
Maintenance procedure
Important
１．
After operation, be sure to empty fluid cup and spray water or
cleaning liquid for cleaning.
・
Turning the fluid adj. valve
counter-clockwise 2
～
3 times and putting
water or cleaning liquid in fluid cup can
stand ready to spray. Blocking the tip of the
air brush with a close or tissue held by a
finger and pushing the main lever can run
air back in order to clean the nozzle inside.
Incomplete cleaning can cause adverse
pattern shape and particles.
*Be careful with handling of the tip of
needle and nozzle since they are very
weak.
２．
Turning the fluid adj. valve
counter-clockwise as shown in the diagram
can be removed from the main body.
・
Loosening needle locking screw
③
can
remove the needle from the fluid
adj. valve.
・
For cleaning each part, use a close
or tissue wetted with cleaning liquid.
2. Never immerse the whole airbrush into liquid
such as thinner.
*Immersion for a long time can damage O ring or
packing.
*Never damage holes of nozzle cap, nozzle, or
needle.
If done, it can influence atomization adversely.
３．
Fully clean fluid passage before disassembly.
３．
When removing the nozzle, loosen the
fluid adj. valve (turn it counter-clockwise
2~3 times) to avoid damage of seat section.
Holding air brush as shown in the right diagram and pushing the
main lever discharges air.
Turning the fluid adj. valve and pushing the main lever ejects fluid.
※
Turn the adj. valve to the left to adjust fluid output since the
valve is closed totally at the start of spraying.
※
Marking on fluid adj. valve can be used as a guide for fluid
output volume.
Spraying pattern can be changed as
below by keeping the air brush close
or away to spraying surface.
Clockwise: Less Paint flow
Counter-Clockwise: More Paint flow
Fluid Adj. Valve