Anest Iwata AP-96-05, Инструкция по эксплуатации, Страница: 11 / 14

- 11 -
3-4 Cleaning and maintenance
Fully clean after job is finished in order to get longer lifetime and good performance at next
job.
WARNING
During painting, be sure to wear protective cover such as glasses, mask or
gloves to avoid serious injury caused by paint or solvent which might enter
your eyes or you might inhale.
Be sure to stop pump and reduce fluid pressure down to 0 pressure before
disassembling airless pole gun.
Only an experienced person who is fully conversant with the equipment can
do maintenance and inspection.
CAUTION
Never use commercial or other parts instead of ANEST IW ATA original
spare parts.
Process W here to clean How to clean Remarks
1 nozzle tip Remove from airless spray gun and clean it.
2 inside of gun body Clean inside of airless spray gun with cleaning
liquid which is compatible with paint being used.
3 filter set
(except ALG-73)
①
Remove No.12 handle from gun body.
②
Remove and clean No.11 filter set.
4. Selection of nozzle tip according to kind of paint
H I N T !
<Numbering system>
Pattern width 25 cm at 30cm spray distance.
Fluid output 0.7ml/sec/cm of width at fluid pressure
9.8MPa (0.98bar
／
14PSI).
NT-25 07
Use nozzle tip with large figures of last 2 digits when you spray paints of high
viscosity or easily clogged.
Usage Kind of paint Model
(NT-
□ □ □ □
)
Remarks
Shipbuilding Rubber chloride paint, 2507-4009 Commonly used
Ship-bottom paint
Tar epoxy paint 3011-4013 Last two digits are large due to
high viscosity.
Zinc rich paint (organic) 2507-4009 Commonly used
Zinc rich paint (non-organic) 3019-4016 Last two digits are large because
it is easy to clog.
Construction W ater base (emulsion paint), 2505-4007 Commonly used
Ready mixed paint
Steel frame Anti-corrosive paint 1507-2513 First two digits are small, and
last two digits are large, for
angle iron.
W oodwork Clear lacquer, 1503-3005 Commonly used
Synthetic resin varnish
Common metal Lacquer, Melamine 1504-4007 Commonly used