17
Installation Procedures
Step 6
Attach the reflector panels (with skirts) by placing them on the ribs and sliding them
inward carefully guiding them until the rib and panel holes align. Place the seam hard-
ware in the fourth hole from the outboard edge on both sides of the panel to set panel
bay spacing, finger tighten only. Install remaining reflector panel hardware, finger tight
only.
Note:
Panels should be installed opposite each other to ensure proper balancing
of the enclosure assembly. Panel 1, Panel 7, Panel 4, Panel 10, etc. as shown in Figure
7. All panels are interchangeable except panels 1, 2 and 12 due to Logo positioning.
Do
not install panel 6 or tighten any panel hardware at this time.
Figure 7
Note:
All panels are interchange-
able except panels 1, 2 and 12.
Note:
All reflector panel hardware
is 1/4-20 x 1-1/4” Socket Head
Capscrews (45055-2), 1/4” Lock
Washers (9974-15) and 1/4” Hex
Nuts (9999-57).
Reference Drawing 240272
Note:
Do not install panel six at
this time to allow easier access to
reflector center for future compo-
nent installation.
