Step 6
Step 7
Step 8
27
Installation Procedures
Insert pivot blocks (P/N 205876) onto the end of the azimuth strut using lubricated 1/2
inch bolt, flatwasher and hex nut as shown in Figure 3-14. A 3/4 inch flat washer should
be inserted between the strut and the spacer block. Tighten hardware according to the
A-325 tensioning procedure.
Figure 3-14: Azimuth Strut Assembly
Slide the round strut assembly bracket (P/N 203875) on the end of the azimuth strut,
and hand tighten the1/2 inch setscrews before mounting it on the ground mount assem-
bly as shown in Figure 3-15.
Figure 3-15: Azimuth Strut-Bracket Assembly
Mount the second azimuth support plate (P/N 205875) pivot assembly to the rear end of
the ground mount assembly as shown in Figure 3-16. Spacer blocks (P/N 205874) and 5/8
inch hardware (hex bolt, flatwasher, hex nut) should be inserted as shown in Figure 3-10.
