Section 4
Edition 3
Rev G
4-14
28. Press the
to advance to the next parameter, DISPLAY FILTER.
29. Press the
and the display advances to the next input to be programmed. Refer to the beginning of this
section, page 4-1.
4.1.2 CONSTANTS
Constants are available only when MATH has been specified and present in the model number order matrix.
From the Normal Display, press the
until CONFIGURATION is seen in the lower display line. If PASS-
WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu-
ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section
9, Enables and Passwords, for instructions to enable Configuration.
With CONFIGURATION in the display, press the
, then the
until CONSTANTS appears in the lower
display line.
1. Press the
to display CONSTANT NUMBER.
Press the
to change, then
or
, then
to desired value,
then press the
.
Press the
to change, then
to
desired number, then press the
.
CONSTANT NUMBER
1
Selections
1 to 12
IVx DISPLAY FILTER
0 SECONDS
Selections
0 to 9999 seconds
I
N
P
U
T
S
&
C
O
S
T
A
N
T
S
Содержание AV-9000
