Edition 3
Rev G
Section 10
10-1
Section 10 - Test
Test describes all possible diagnostic tests built into the recorder.
From the Normal Display, depress the
until TESTS appears in the lower display line. If PASSWORD
appears in the lower display line, the correct "password" will need to be entered before access to Test is allowed.
If TESTS is not displayed, then Test has been disabled. Refer to Section 9, Enables and Passwords, for instruc-
tions to enable Test.
A list of available tests and their purpose are shown in Table 10-1.
TABLE 10-1 AVAILABLE TEST
Relays
Used to verify that all LEDs, Relays and/or Solid State Relay Drivers (SSRD) are
working correctly.
Display
Used to verify the display is functional.
Keypad
Used to verify that all keys are functional.
LEDs
Used to verify that the functionality of the LEDs.
Chart Demonstration
Used to demonstrate chart capabilites.
CAUTION: When this test is iniitated, any parameter values previously
programmed in Chart Configuration and Recorders are replaced with the
demonstration values.
A/D Reset Counter
Displays the number of times the A/D counter has been reset.
FACTORY USE ONLY!
A/D Raw Hex Counts
Displays raw counts for inputs and grounds. FACTORY USE ONLY!
Calibrated Input Values
Displays calibrated input values for inputs and grounds. FACTORY USE ONLY!
mA Output
Used to verify the mA Output is functional.
Содержание AV-9000
