Section 13
Edition 3
Rev G
13-10
14.Press the
to advance to the next parameter, AUTO MANUAL AUTO TRANSFER (only if MANUAL
ACTUATOR is not NONE/OFF).
Cx AUTO M/A TRANSFER
OFF
Selections
OFF ON
NOTE: If the process variable
reaches setpoint while in manual
mode, this parameter, when selected,
allows the controller to revert to
automatic mode without operator
intervention.
15.Press the
to advance to the next parameter, MAIN SETPOINT SOURCE.
Cx MAIN SP SOURCE
SPx
Selections
NONE USED
IV1 IV2 IV3 IV4
IV5 IV6 IV7 IV8
PV1 PV2 PV3 PV4
DV1 DV2 DV3
DV4 DV5 DV6
DV7 DV8 DV9
DV10 DV11 DV12
CV1 CV2 CV3 CV4
CV5 CV6 CV7 CV8
CV9 CV10 CV11 CV12
TOTAL 1 TOTAL 2
TOTAL 3 TOTAL 4
SP1 SP2 SP3 SP4
SP5 SP6 SP7 SP8
OUTPUT 11 OUTPUT 12
OUTPUT 21 OUTPUT 22
OUTPUT 31 OUTPUT 32
OUTPUT 41 OUTPUT 42
SV1 SV2 SV3 SV4
NOTE: Whatever value is selected
as the source of the setpoint, the
decimal position and the units type
follow what was configured in
Process Variables.
Press the
to change, then
,
to desired choice, then press the
.
Press the
to change, then
or
to desired choice, then press the
.
Содержание AV-9000
