p3
E1 Single Speed Electric Motor Unit, 12V & 24V
To Suit Self-Tailing Winch Sizes 28,34,40
FEATURES
INCLUDED
REQUIRED
• Highest quality winch featuring a stainless
steel drum for ultimate durability and style,
vertical Power Ribs
™
for maximum grip and
minimum rope wear, and superior engineering
for reliability, long service life and low
maintenance.
• Easy to install and service. The motor unit has
internal controller and contactors so electrical
connection is simple. The winch can be
serviced without removing it from the deck,
independent of the motor unit.
• Illuminated “intelligent” push button with
integrated LED to indicate system power on,
and in conjunction with the controller will flash
status codes that assist with trouble shooting.
•
High quality European engineered and
manufactured motor, with matched gearbox
for optimal speed and load capacity.
• Unrivalled levels of monitoring and protection
including: Integrated Overload Protection,
Thermal Overload Protection, Accidental
Start Protection, Low Voltage Detection,
Continuous Run Time Limiting.
• The motor unit can be rotated relative to the
winch to suit restricted under-deck space
(8 positions at 45° increments)
• 2 speed manual winch operation is always
possible by simply inserting a standard
winch handle.
Included in your E1 Electric Motor Kit:
•
Motor unit
•
Deck plate [7]
•
Gear wheel [3]
• Push button incl. 500 mm (19 5/8”)
control cable [A1]
•
Push button Gasket [A2]
•
5 pcs. (4 for 28/34) M6 x 16mm
countersunk socket head screws [6]
•
3 pcs. #6 x 19 mm screws [A9]
•
Eye-bolt M6 [A6]
•
4 mm Allen key [A4]
•
5 mm Allen key [A5]
•
Pin spanner (5 mm pins) [A8]
•
Product manual [A10]
•
Drilling template [A3]
•
Application sticker set [A7]
Numbers in
[ ]
above and in instructions refer
to the item number in the parts list, see page 4,5
Tools & fasteners required for installation:
•
Phillips head screwdrivers - #1 & #2
•
4 mm Allen key (included)
•
5 mm Allen key (included)
•
Pin spanner, 5 mm pins (included)
•
Ø6.5 mm (1/4’’) drill
•
Ø85 mm (3 3/8’’) hole-saw, or jigsaw
•
5 pcs. M6 (1/4’’) countersunk head bolt and
nut (length as required for deck thickness)
• 5 pcs. large diameter M6 (1/4”) ID washers
or backing plate (to match drilling template)
•
10 mm AF spanner for M6 Nyloc nuts, or
7/16” AF spanner for 1/4” Nyloc nuts
•
Solvent (white spirits/mineral spirits) -
to clean deck etc prior to applying sealant
•
Sealing compound
•
Ø3 mm (1/8’’) drill
•
Ø25 mm (1’’) drill or hole saw
•
Wire crimping tool/pliers
•
Marine grade electrical power wire with
Ø8 mm terminals (see table page 10)
•
Circuit breaker/fuse; available separately
(see table page 10)
•
Cable fastening clips
Please read this product manual & the relevant winch manual fully before installation or operation.
