ANDELI MIG-270TPL, Руководство пользователя

Страница: 9 / 27

8
5.INSTALLATION
5.1. MIG Welding Set Up & Operation
5.1.1 Fitting the spool
5.1.1.1 open the cover door for the wire feed compartment. Remove the wire spool retainer(25) by threading off anti
clockwise.
5.1.1.2 fit the 200mm diameter wire spool to the spool holder, ensuring the end of the wires exits towards the wire
feeder from the bottom of the spool. Refit the wire spool retainer(25) and tighten finger tight.
5.1.1.3 set the spool brake tension by rotating the adjustment screw(26) using an Allen wrench. Clockwise to increase
brake tension, anti-clockwise to decrease brake tension. The spool brake tension should be set so that the spool can
rotate freely, but does not continue to rotate once the wire feed stops. This may need to be adjusted as the wire is used
up and the spool weight decreases.
20. Wire tension adjustment
21. Wire tension arm & support roller
22. Wire input guide
23. Wire drive roller
24. Drive roller retainer
25. Wire spool retainer
26. Spool brake adjustment
27
28
29
30
31
32 33
34
27. Torch trigger switch
28. Torch “Euro” connector
29. Workpiece earth clamp
30. Earth lead quick connector
31. Conical gas nozzle/shroud
32. Welding tip
33. Shroud spring
34. Tip adapter
20
21
22 23
24
25
26