AND UT-201BLE, Инструкция по эксплуатации

Страница: 12 / 22

English 11
Using the Thermometer
Measurement and Transmitting Data
The communication performs the following steps after building the paring.
Keep the condition of the receiver device so as to communicate.
1. Turn on the thermometer. Data is measured automatically.
2. Data is transmitted after finishing the measurement.
Transmitting Temporarily Stored Data
In cases when the receiver device cannot receive measurement data, the
measurement data is temporarily stored in the thermometer memory. The
data stored in the memory is transmitted the next time a connection is
successfully made to the receiver device
A total of 90 sets of measurement data can be stored. When the amount of
data exceeds 90 sets, the oldest data is deleted and the new data is stored.
The amount of data that can be stored temporarily may vary with the
application.
Time
This thermometer has a built-in clock. The date and time that a
measurement was taken is included in the measurement data.
The built-in clock is designed to be automatically adjusted by syncing with
the clock of a receiver device. Refer to the specifications of the receiver
device. This thermometer has no clock adjustment function.
Changing Units
1. Press and hold the switch above 6 seconds when turning off the
thermometer. The new unit is displayed after blinking the last unit.
The thermometer turns off automatically.
2. When the same operation is
performed again, an effective unit
is exchanged.
The unit is stored in the memory.
The unit of the factory setting
is °C (centigrade).
Turn off the device.
Press and hold the
switch above six seconds.
Last unit
New unit
The device is turned off automatically.