LifeSource Health Line (Toll-Free): 1-888-726-9966
E-4
You must install 1 type AA (1.5 volt) battery and attach the cuff to the monitor
before using it (alkaline battery recommended). To install battery (or replace it
if the "Low Battery" symbol appears on display), proceed as follows:
1.
Remove battery cover by gently pushing
down on handle and pulling cover off
monitor.
2.
Place the battery in compartment with pos-
itive (+) and negative (–) terminals match-
ing those indicated in the compartment. Be
sure battery makes contact with compart-
ment terminals.
3.
Replace cover by sliding it into the com-
partment and gently pressing into place.
NOTE: Do not pull or remove air tubes from monitor.
NOTE: Rechargeable batteries will not work with this monitor.
LifeSource
®
blood pressure monitors are easy to use, accurate and digitally
display full measurement readouts. Our technology is based on the “oscillo-
metric method” – a noninvasive blood pressure determination. The term
“oscillation” refers to any measure of vibrations caused by the arterial pulse.
Our monitor examines the pulsatile pressure generated by the arterial wall as
it expands and contracts against the cuff with each heartbeat.
The cuff is inflated until the artery is fully blocked. The inflation speed is
maximized and the pressure level is optimized by the device. The monitor
takes measurements while the cuff is both inflating and deflating. This results
in a faster measurement providing greater comfort to the user.
HOW UA-704 WORKS
?
BEFORE YOU START
? !
BATTERY
COVER
HANDLE
BATTERY
