Anchor VMS 25x32, Руководство по сборке

Страница: 13 / 16

13
STEP 10 - Pull second mid panel into place.
•
Proceed as with the first mid.
Your Vehicle Maintenance Shelter is now ready for use.
STEP 11 - Pull first gable end into place
• Be certain that the zippers of the Gable End are unzipped for ease of installation.
•
Lay out one half of gable end panel at bottom of the appropriate end leg. White side of gable end to inside of tent and lace
edge goes in first. See figures 11a and 11b.
• Insert lace edge end of kedar into slotted opening of top/outer channel of lower leg. Push the inserted kedar up the channel
of the leg as far as possible (to about the corner). The zipper tool will be required to push the kedar up past the corner.
• Once the kedar is past the corner, the zipper tool may be used to guide the pull rope while another person pulls on the rope
until the lace edge of the gable end reaches the peak point of the frame.
See figure 11a.
• Disconnect the pull rope.
• Repeat this process for the other side of the gable end.
• Go back to the slots where you started gable end installations, and stuff the remaining kedar into the lower channels below
the slotted openings down to bottom of leg.
• Join the two halves of the gable end at top and bottom with the carabiners attached to the top and bottom rings on the loop
side.
• Using a ladder, start lacing at the top of the gable and continue lacing until you reach the bottom loop. Tie off bottom loop.
As you are lacing, cover lacing with the protective flap and velcro closed.
• Gable end may be staked with stakes provided.
Figure 11a
Figure 11b
Pull rope snapped onto
ring of Gable end.
Gable end
Lower
Leg.
Slotted
Opening
Slotted
Opening
Kedar of
Gable end
.
Pull rope
Lace Edge
Slotted
Opening
Zipper
Tool