Anchor VMS 25x32, Руководство по сборке

Страница: 11 / 16

11
Turnbuckles are
toward the Base
Plates.
STEP 8 - Attach X Cables.
•
Hook the cables into position as
shown. Note the turnbuckles are at the
bottom for ease of access and adjust-
ment.
See figure 8 .
• Tension the cables to square the
frame. Use a level if possible to check
the squareness of the frame. If no level
is available, the gap in the turnbuckles
should be approximately equal.
Figure 8
STEP 9 - Pull first fabric mid panel into place.
•
Throw the snap ends of the two (2) pull ropes from the installa-
tion kit over the top of frame. See Figure 9b.
• CAUTION: Be certain area is clear so as not to strike any-
one while throwing the pull ropes over the top.
•
Lay the mid fabric next to the bottom of the legs. Mid should
be loosely stacked to permit feeding into the slots near the top
of the lower legs.
• Snap the pull ropes onto the rings of the mid.
• Insert kedar ends of mids into slots (See Kedar in
Figure 9a ).
• Two (2) to four (4) persons pull the fabric over the top of the
frame down to the bottom of the far leg, while two (2) persons
guide the edges into the slots.
See Figure 9b.
• Disconnect the pull lines.
• CAUTION: Be certain at all times that fabric is not caught
on any part of the frame to prevent damage to the fabric.
• Insert the trailing kedar edges into the slots and work back
down to the bottom of the near leg.
• Remove the half-purlins and splices from the frame lifts and
attach the remaining half purlins to create four (4) purlins which
will now be used as ground bars to secure and tension the lower
edges of the mid panels.
• Loosen and release the bottom of the X-Cables to permit
installation of the ground bars.
Snap ends of
Pull ropes.
Figure 9b
Figure 9c
Slot in channel
Figure 9a
Kedar for sliding fabric
into frame channel.