GENERAL OPERATION
9
SYSTEM SETUP
4
Mic 1
(MEGA-6000 only)
An unbalanced, low impedance microphone input. For use with the
wired mic supplied with your unit, or any mic with a 1/4" phone
plug which does not require phantom power.
Mic 1/Wireless
(MEGA-6000U1 only)
The built-in receiver is connected to this input. Use the controller to
adjust the wireless mic volume. Inserting a plug into this input
disconnects the wireless input—to use a wired and wireless mic
simultaneously, plug the wired mic into the Mic 2 input.
Mic 2/Signal
An unbalanced, low impedance microphone input. For use with the
wired mic supplied with your unit, or any mic with a 1/4" phone
plug which does not require phantom power. The controller adjusts
both the signal alert and mic volume.
Line In
The line input (1/4"-phone jack) is used for playback of a tape
player, musical instrument or similar source. It may be used
simultaneously with the mic inputs for a composite output.
Line Out
The output signal is a composite of all the inputs. Use it to record
your presentation, or to “daisy chain” another powered sound system
to the MegaVox Pro for greater crowd coverage.
Speaker Out
Use the speaker output to drive Anchor’s model MEGA-6001
companion speaker (in addition to MegaVox Pro's built-in speakers)
for greater output. When an external speaker is powered by the
MegaVox Pro, battery service per charge will decrease considerably.
Signal Alert Button
The Signal Alert provides an air horn type tone. The level is
controlled by the MIC/SIGNAL volume control. Caution, this can
produce VERY high or harmful sound pressure levels.
Single Unit Setup
Place the unit along the aisle with the least amount of pedestrian
traffic. Point the unit towards the center of the audience.
Connect A MegaVox Pro Companion Speaker
Use a speaker cable (SC-50) to connect Speaker Out on the primary
unit to the unpowered companion speaker (MEGA-6001).
No electric power is required for an unpowered companion speaker.
Connect MegaVox Pro Powered Systems
Utilize the Line Output feature by connecting a cable (EX-50PP)
from Line Out of the primary MegaVox Pro to Line In on the
secondary powered MegaVox Pro. Connect the second MegaVox
Pro to an electrical outlet and turn the unit on. Set the volume of the
second Megavox Pro to maximum so full volume control will be at
the primary system.
NOTE:
The line-out
connection
can also be
used to send
the signal to a
sound system
in a different
room or a
recording
device.
Secondary
Powered
MegaVox Pro
Line Out - to - Line In Connection
Primary
Powered
MegaVox Pro
