AMD5x Passive Infeed Unit and AMD5x Servo Drive - User Guide
ANCA MOTION
D-000129 Rev 09
150
10.8.2.2
European Low Voltage Directive EN 61800-5-1
The object of this standard (61800-5-1) is to specify requirements for adjustable speed Power Drive Systems
(PDS) or their elements with respect to electrical, thermal and energy safety considerations. The AMD5x PIUs
and Drives are considered to be protective Class I PDS, and comply with the standard with the following
provisions:
1. The PIU and Drives are installed and maintained according to the instructions given in this manual.
Definitions
Protective Class I
Equipment in which protection against electric shock does not rely on basic insulation only, but
which includes an additional safety precaution in such a way that means are provided for the
connection of accessible conductive parts to the protective (earthing) conductor in the fixed
wiring of the installation, so that accessible conductive parts cannot become live in the event of
a failure in the basic insulation.
10.8.2.3
European Low Voltage Directive EN 61000-3-12
The object of this standard (61000-3-12) is define the limits and test methods for a Power Drive System (PDS)
according to its intended use, whether residential, commercial or industrial. The standard defines limits for
voltage disturbances and harmonics produced by the PDS, and the methods for ascertaining compliance to the
limits in order to maintain electromagnetic compatibility within the electrical network. The AMD5x PIU and drive
comply with the standard with the following provisions:
1. The PIU and Drives are installed and maintained according to the instructions given in this manual.
2. The PIU and Drives are installed with a line inductor as defined by
components for a 380-480V L-L 3 Phase supply.
3. The PIU and Drives are installed in an environment where the mains supply R
sce
≥ 350
4. The PIU is operated at rated load.
for compliance at loads less than rated.
Definitions
R
sce
Short circuit ratio.
The ratio of the short circuit power of the source at a defined PCC
(S
sc
), to the rated power of the equipment (S
equ
) .
R
sce
= S
sc
/ S
equ
FCC Marking
10.8.3
A FCC mark is attached to the Product Label in order to verify that the unit meets the relevant Electromagnetic
Compliance (EMC) standards of the Federal Communications Commission.
All AMD5x PIUs and 20A, 12A, 6A , 3A drive variants, and capacitor modules are FCC compliant.
