ATI
Q45C2 2E Conductivity System
Part 2– Analyzer Mounting
O & M Manual
Revision K (01/07)
- 14 -
2.3
Panel Mount, 2-wire Transmitter
The instrument may be panel mounted in two different ways: In the 2-wire
configuration, the front half of the enclosure may be separated and mounted by
itself, as shown in Figure 2-6. Note that the rear of the instrument enclosure is
not utilized in this mounting scheme. Holes must be drilled at the perimeter of
the panel cut-out that allow the enclosure screws to pass through and be
retained on the back side. User-supplied #8-32 nuts are used to fasten the
instrument from the back. The FIP instrument gasket remains intact during this
mount to seal to the panel.
Figure 2-6 2-Wire Panel Mount and Cut-out (ATI-0661)
PANEL MOUNT
3.54
(90.0)
3.54
(90.0)
3.75
(95.2)
3.75
(95.2)
#8-32 UNC
(4 PLACES)
