Analytic Systems BCA1000R, Руководство по установке и эксплуатации

Страница: 8 / 16

8
Operation
Turn the switch on the front panel of the unit on to energize the outputs. The green ‘Power
On’ indicator light will glow to indicate the proper operation of the unit. The Digital Meter
will show the voltage and current on either output 1 or output 2. Flip the toggle switch to
view the voltage and current on the other output. If the battery is connected in parallel, then
you will have to add the currents on each output to see the total charging current.
OUTPUT ADJUSTMENT
The unit has an adjustment potentiometer to allow up to ± 1.0V adjustment of the output
voltage. This potentiometer is accessed through a small hole in the front panel of the Battery
Charger. As shipped from the factory, the unit is preset for a voltage of 13.6, 27.2, 36.3 or
A dry contact relay to indicate output failure is supplied standard. There is a plug just below
the main output connector that is used to connect to this relay. Simply determine if you
require a normally open or normally closed contact to indicate charger failure and connect
to the appropriate points on the plug. If you determine that the opposite function is required,
move 1 wire from the normally open connection to the normally closed connection.
Dry Contact Relay
OUTPUT 1 OUTPUT 1
OUTPUT 2 OUTPUT 2
BATTERY
BANK #1
BATTERY
BANK #1
BATTERY
BANK #2
If the batteries are connected in reverse, the output fuses will blow. Turn the unit off, correct
the wiring and then replace the fuses.
BATTERY TEMPERATURE SENSORS
Up to 2 battery temperature sensors can be connected to the charger to allow temperature
compensation of the battery charging voltage (1 is supplied with the unit). If only the 1 sensor
is used, it MUST be plugged into the ‘BATTERY 1’ connection on the rear of the unit. If no
sensor is used, the charger will default to standard output voltage.
The battery temperature sensor(s) must be physically attached to the battery bank(s) so that
it(they) can sense the temperature of the battery bank(s).