ANALOX CO Clear, Руководство пользователя

Страница: 5 / 24

CO Clear
User Manual
Int. Approved
Document ref: ACO-810-28 October 2018 Page 5 of 24
Copyright © 2006 Analox Ltd. All Rights Reserved.
Commercial in Confidence
The Analox CO Clear is designed to be compliant with the following standards: EN61010-1:
2001, IEC61010-1: 2001, CAN/CSA-C22.2 No. 61010-1 Second Edition 2004, ANSI/UL
61010-1 Second Edition 2005. It is designed to be safe at least under the following
conditions.
• Indoor use
• Altitude up to 2000m
• Temperature -5°C to +40°C
• Maximum relative humidity 80% for temperatures up to 31°C decreasing linearly
to 50% relative humidity at 40°C.
• Mains voltage supply fluctuations not to exceed 10% of the nominal voltage
• Impulse withstand (over-voltage) category II of IEC 60364-4-443
• Pollution degree 2
• Mains voltage: -
230V AC
(Not Adjustable - Instrument will be factory set)
110V AC (Not Adjustable - Instrument will be factory set)
24V DC (Not Adjustable - Instrument will be factory set)
• Mains power: -
Less than 5VA
– 110V AC and 230V AC Versions
Less than 5W – 24V DC Version.
• Mains frequency - 50/60Hz
• The Remote Alarm Repeater has ingress protection to IP43: direct sprays of water
up to 60° from the vertical in accordance with EN 60529:1991 + A1. All other
units have ingress protection to IP65: low pressure water jets from all directions
and totally protected from dust in accordance with EN 60529:1991 + A1.
• Insulation: - Reinforced insulation, class II product according to IEC536.
• Not for use in corrosive or explosive atmospheres
• Not approved for use in vehicles, ships or aircraft
1.2 Fuse ratings
Table 2 Fuse ratings
230V AC, 500mA F rating 250V (20mm x 5mm Glass Cartridge)
110V AC, 500mA F rating 250V (20mm x 5mm Glass Cartridge)
9-24V DC, 200mA AS rating 250V (20mm x 5mm Glass Cartridge)
1.3 Other information
Battery Back-Up
The Battery Back-Up is non-repairable. Please return faulty units to Analox for
refurbishment or replacement.
4 to 20mA (or 0-1V) Output
Connected equipment must meet the requirements for reinforced insulation.
NOTE: IF THE EQUIPMENT IS USED IN A MANNER NOT
SPECIFIED BY THE MANUFACTURER, THE PROTECTION
PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED.