UG-200
Evaluation Board User Guide
Rev. 0 | Page 8 of 28
Applying Input Signal and Optimizing SFDR
Apply the input signal as follows:
1.
Apply the input signal so that the fundamental is at the
desired level (examine the
Fund Power
reading in the left
panel of the
VisualAnalog FFT
window). See Figure 11
and Figure 12.
09
43
6-
0
11
Figure 11. VisualAnalog, FFT Graph, No Signal or Very Low Signal Applied
09
43
6-
0
12
Figure 12. VisualAnalog, FFT Graph, Full-Scale Signal Applied
09
43
6-
0
13
Figure 13. Typical FFT, AD9467 (No Buffer Current Optimization)
2.
To optimize SFDR performance, use Register 36 and
Register 107 to change the buffer current setting. In the
ADCBase 0
tab of the SPI Controller, find the
BUFFER(36)
/
BUFFER(107)
box. Use the drop-down list box to select
the best current, if necessary. See the AD9467 data sheet, the
AN-878
Application Note, and the
AN-877
Application
Note for reference.
0
94
36-
01
4
Figure 14. SPI Controller, BUFFER(36)/BUFFER(107)
Содержание UG-200
