Analog Devices TigerSHARC ADSP-TS201S, Технические характеристики

Страница: 24 / 48

Rev. C | Page 24 of 48 | December 2006
ADSP-TS201S
TIMING SPECIFICATIONS
With the exception of DMAR3–0, IRQ3–0, TMR0E, and
FLAG3–0 (input only) pins, all ac timing for the ADSP-TS201S
processor is relative to a reference clock edge. Because input
setup/hold, output valid/hold, and output enable/disable times
are relative to a clock edge, the timing data for the ADSP-
TS201S processor has few calculated (formula-based) values.
For information on ac timing, see
General AC Timing . For
information on link port transfer timing, see Link Port Low
Voltage, Differential-Signal (LVDS) Electrical Characteristics,
and Timing on Page 30
.
General AC Timing
Timing is measured on signals when they cross the 1.25 V level
as described in
Figure 15 on Page 29 . All delays (in nanosec-
onds) are measured between the point that the first signal
reaches 1.25 V and the point that the second signal reaches
1.25 V.
The general ac timing data appears in Table 22 and Table 29 . All
ac specifications are measured with the load specified in
Figure 36 on Page 38 , and with the output drive strength set to
strength 4. In order to calculate the output valid and hold times
for different load conditions and/or output drive strengths, refer
to
Figure 37 on Page 38 through Figure 44 on Page 39 (Rise and
Fall Time vs. Load Capacitance) and Figure 45 on Page 39 (Out-
put Valid vs. Load Capacitance and Drive Strength).
The ac asynchronous timing data for the IRQ3–0, DMAR3–0,
FLAG3–0, and TMR0E pins appears in
Table 21 .
Table 21. AC Asynchronous Signal Specifications
Name Description Pulse Width Low (Min) Pulse Width High (Min)
IRQ3–0
1
Interrupt Request 2 × t
SCLK
ns 2 × t
SCLK
ns
DMAR3–0
1
DMA Request 2 × t
SCLK
ns 2 × t
SCLK
ns
FLAG3–0
2
FLAG3–0 Input 2 ×t
SCLK
ns 2× t
SCLK
ns
TMR0E
3
Timer 0 Expired 4 ×t
SCLK
ns —
1
These input pins have Schmitt triggers and therefore do not need to be synchronized to a clock reference.
2
For output specifications on FLAG3–0 pins, see Table 29 .
3
This pin is a strap option. During reset, an internal resistor pulls the pin low.
Table 22. Reference Clocks—Core Clock (CCLK) Cycle Time
Parameter Description
Grade = 060 (600 MHz) Grade = 050 (500 MHz)
Unit Min Max Min Max
t
CCLK
1
Core Clock Cycle Time 1.67 12.5 2.0 12.5 ns
1
CCLK is the internal processor clock or instruction cycle time. The period of this clock is equal to the system clock period (t
SCLK
) divided by the system clock ratio
(SCLKRAT2–0). For information on available part numbers for different internal processor clock rates, see the Ordering Guide on Page 46 .
Figure 9. Reference Clocks—Core Clock (CCLK) Cycle Time
CCLK
t
CCLK