Analog Devices EVAL-ADF7023DBxZ, Руководство пользователя

Страница: 33 / 49

R e v 1 . 1 | Page
33
Configuring the Transmitter board for the PER test
1. Once all of the Transmitter and packet parameters are setup correctly (as in Tx Setup in Packet Mode section)
then select the “ PER ” Tab. (
Figure 40
point ( 1 ))
2. Select the “ Tx Board Setup ” Tab ( Figure 40 point ( 2 ))
3. Set the number of packets to be received, “ No. of Packets to Tx ” (
Figure 40
point ( 3 ))
(Note: Ensure the number of packets on the Receive and Transmit side are set the same.)
4. Set the delay between each transmitted packet from the “ Delay Between Packets ” dropdown menu.
( Figure 40 point ( 4 ))
5. Write these settings to the uC by clicking “ Write Tx Settings ” (
Figure 40
point ( 5 ))
6. To begin the test and put the receiver into Tx click “ Begin PER Tx ” (
Figure 40
point ( 5 ))
(Note: The transmitter will continuously transmit packets until “
No. of Packets to Tx
” value is reached.)
7. If at any time you wish to terminate the test manually press “Stop Test ”.
(
Figure 40
point
(6 ))
(Note: The test will stop automatically once the transmitter has transmitted the final packet.)
Figure 40