UG-797
EVAL-ADE7903EBZ User Guide
Rev. 0 | Page 8 of 12
MAIN WINDOW
When the software is launched, the main window opens. This
window contains two areas: the main menu on the left, and a
box that verifies that the PC is connected to the SDP-B board
on the right (see Figure 11).
The software automatically detects the SDP-B Blackfin board.
If the port detection is successful, the box on the right displays
Connected
, as shown in Figure 11.
The
Function
menu, shown in Figure 12 at the top of the
window, appears in every window throughout the software.
With this menu, navigate from any main menu selection to
another main menu selection at any time.
Figure 11. Main Window of the
ADE7903
Evaluation Software
Figure 12.
Function
Menu on Main Window
Troubleshooting the COM Port Detection
If the software does not detect the SDP-B Blackfin board, the
message shown in Figure 13 displays.
Figure 13. SDP-B Blackfin Board Not Detected Message
Wait approximately 40 seconds and click
Rescan
to retry
connecting to the SDP-B board. If a message stating
1 matching
system found
does not appear, take the following steps:
1.
Click
Cancel
and
Exit
out of the evaluation software.
2.
Verify that the
ADE7903
board is connected to the SDP-B
Blackfin board and that the SDP-B Blackfin board is
connected to the PC using the USB cable.
3.
Ensure that the required drivers are installed as described
in the Installing the Drivers section. Some drivers are
automatically installed during the first startup of the board.
Drivers only need to be installed once for a particular PC.
4.
Using the
Device Manager
tool, ensure that the SDP-B
Blackfin board was recognized by the PC and appears
under the
ADI Development Tool
s entry as
Analog
Devices System Demonstration Platform SDP-B
.
5.
Launch the
ADE7903
evaluation software again.
12927-
0
1
1
129
27-
012
129
27-
013
