Evaluation Board User Guide
UG-478
Rev. 0 | Page 3 of 40
EVAL-AD7176-2SDZ
QUICK START GUIDE
To begin using the evaluation board, do the following:
1.
With the
EVAL-SDP-CB1Z
board disconnected from the
USB port of the PC, install the
AD7176-2
evaluation board
software from the CD included in the evaluation board kit.
The PC must be restarted after the software installation is
complete. (For complete software installation instructions,
see the Software Installation Procedures section.)
2.
Connect the
EVAL-SDP-CB1Z
board to the
EVAL-
AD7176-2SDZ
board as shown in Figure 2.
a.
Screw the two boards together using the plastic screw-
washer set included in the evaluation board kit to
ensure that the boards are connected firmly together.
3.
Apply an external voltage in the range of 7 V to 9 V to the
J4 or J5 connecter of the
EVAL-AD7176-2SDZ
board, as
shown in Figure 2 (see Table 3 for more information). This
provides the power supply for the board.
4.
Connect the
EVAL-SDP-CB1Z
board to the PC using the
supplied USB cable. If you are using Windows® XP, you may
need to search for the
EVAL-SDP-CB1Z
drivers. Choose to
automatically search for the drivers for the
EVAL-SDP-
CB1Z
board if prompted by the operating system.
5.
Launch the
EVAL-AD7176-2SDZ
software from the
Analog Devices
subfolder in the
Programs
menu.
Figure 2. Hardware Configuration—Setting Up the
EVAL-AD7176-2SDZ
11035-
002
Содержание EVAL-AD7176-2SZD
