R e v 1 . 1
| Page
27
Tx Setup in Packet Mode
The settings which follow are for use with EVAL-ADF7023DB1z daughter boards. If you are using a
different Daughter board, ensure that the frequency is set within the correct range of the board you are
using. Please refer to table x if you are unsure what the frequency range of you board is designed for.
Transmitter Board RF Settings
1.
Ensure the
S
econd
ADF7023 Daughter board is correctly plugged into the
Second
Mother board and that the
“
Current_State
” is “
PHY_ON
” on the
Second
instance of the ADF7023 Software.
Refer to
Connecting the Evaluation Boards
section for setup procedures.
2.
Select the “
RF Settings
” Tab (
Figure 34
point (
1
))
3.
Ensure “
Packet mode
” is selected. (
Figure 34
point (
2
))
4.
Set the “
RF/Modulation”
parameters as required. (
Figure 34
point (
3
))
(Note : Ensure the
Transmitter
RF/Modulation
parameters are the same as the
Receiver
RF/Modulation
parameters previously setup).
5.
Set the “
Transmitter”
parameters as required. (
Figure 34
point (
4
))
Figure 34
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from