15
A
B
C
А
- Control buttons
В
– electronic blocking buttons
С
– LED
Pic. 6. Radio control board
Таблица 7. Запоминание и стирание пультов радиоуправления
Action
Indicator
A) Board entering in the memory of the control unit
-
1
Press button
«CODE»
2
When you see the indicator
«Su» press 1...2с chosen button on the con-
sole (one of the buttons
А, pic. 6)
3
Pres once again 1...2
с the same button on the control unit. The indicator
briefly blinks
«Su», after that the control unit will be adjusted in the waiting
mode.
-
When the control unit is programmed to 20 consoles you will see the indi-
cator
«Fu»
B) Board deleting from the memory of the control unit
-
1
Press and hold button
«CODE» within 8 sec, you will see the indicator
«dL», which confirms deleting of all programmed consoles (codes) from
the memory of the control unit
2
Release button
«CODE», after that the drive will be adjusted in the waiting
mode.
!
Before the first programming of the board clean the memory of radio receiver from
the codes programmed before.
!
If the console is lost you must delete all codes from the memory of the control unit
and program them once again to avoid the illegal intrusion into the premises.
7. TESTING AND COMMISSIONING
This is the most important stage of drive system installation as it can ensure the highest level
of security.
7.1. Testing
After installation, connection and adjustment of the drive it is necessary to check the proper
functioning of the drive system.
Each additional device for example, photo cells requires individual testing. It is recommended
to implement all the procedures described in the present manual.
Testing is performed in the following way:
Make sure that instructions from the section “General information and safety measures” are
fully observed.
Check the firmness of connection between the drive and the rail, it must be reliable and
suitable for the loads even if the doors are opened and stopped sharply.
Check the chain tension and if it in necessary tighten it.
Unblock the carriage pulling down the unblocking rope. Open and close the doors several
times manually. Make sure that there are no points of increased resistance to movement
and no defects after assembling and adjustment. Return the carriage into blocked position.
Содержание ASG1000/3KIT
Страница 22: ...22 Notes...
Страница 23: ...23 Notes...