INSTALLATION INSTRUCTIONS
Step 1-3
1. Drill two 8mm holes in position for Wall Anchor (Part B) placement.
2. Tap Wall Anchors securely into each of the drilled holes.
3. After Wall Anchors have been tapped in place, Insert st5 Screws,
but leave 1/4 of the screw sticking out of the wall.
(This will give
your Range hood something to hang onto).
Step 4 Step 5
4. Install the 6" round Aluminum duct, secure the round aluminum
duct to the vent hole at the top of the hood unit using HVAC
Aluminum foil tape. (Not available. to be purchased)
If mounting to a cabinet, skip step 5 and proceed with step 6-11.
5. If mounting to the wall only, drill a 6-1/4 round hole on the back wall
above the hood, OR into the ceiling directly above the hood.
5a. Remove baffle filters from underneath the hood and set them aside.
5b. Lift the hood and hang the hood unit on the back wall using the
screws drilled in Step 3. Once the hood is securely hung on the wall,
tighten the screws from the interior of the hood.
5c. Pull round aluminum duct through the newly drilled hole in the wall.
Plug unit into power outlet. Reinstall baffle filters.
+
8mm Hole
+
8mm Hole
27.56"
+
1/4"
Spacing
Wall
8
BACK
OF
UNIT
OR
