AMX ViewStat, Инструкция по эксплуатации

Страница: 33 / 76

ViewStat Installation and Wiring
27
ViewStat Communicating Thermostat
Address the Thermostats and Set Highest Address
1. Press the Mode and Enter buttons simultaneously at the thermostat. It may take a couple of
tries to get them pressed together.
This will enter the Thermostat Set Up Menu. The first menu item that will appear on the text
messaging display is an informational item that indicates that only the Scroll Up, Scroll Down
(two buttons located immediately to the right of the text display) and the Enter buttons are used
in thermostat set up. This will remain on the display for approximately 5 seconds or until any
of the three aforementioned buttons are pressed. Thermostat Set Up is a series of sub-menu's
that allow you to customize the ViewStat in various ways. The Set Up and
Configuration section on page 45 outlines the set up features. The following steps will guide
you only through Communications Set Up sub-menu (FIG. 17).
2. Press the Scroll Down button until the "Communications Set Up" menu shows on the display.
3. Press the Enter button to select this menu.
4. The first sub-menu item is "Set Thermostat ADDRESS". Press the Enter button to select this
item.
5. Set the address between 1 and 64 using the Scroll Up and Scroll Down buttons.
Each thermostat must have a unique address (i.e. no two thermostats can have the same
address)
These steps must be done at each thermostat for communication to work properly.
FIG. 17 Setting the thermostat address
Network Address
Communications
Set Up More
Set Thermostat
Address
EXIT
Back
1 to 64
Next
No.of T-stats On
the Network
Set Baud
Rate More
Select
9600