34
Wiring and Device Connections
HDMI INPUTS (3-6)
The HDMI INPUT connectors on the rear panel are used to connect source input devices to the presentation system. The
presentation system routes digital video and audio from connected source input devices to the connected output devices. These
ports support HDMI (with Deep Color) and HDCP 2.2.
NOTE:
When an input sends protected content to a non-HDCP compliant monitor, the video output displays a black screen rather
than a red screen as displayed via Enova DVX Presentation Switchers.
These inputs support 2 CH L-PCM.
The following table describes the pinout configuration of the HDMI INPUTS connectors:
FIG. 29 displays the pin locations for the HDMI pinouts:
FIG. 29
HDMI pinouts
To connect HDMI input source devices (DVI and HDMI) to the HDMI INPUT connectors, the following (optional) adapter cables
are required:
DXLITE INPUTS (7-8)
Two DXLite (RJ-45) connectors transport digital video, embedded audio, and bi-directional control over twisted pair cable to
DXLink devices or boards, including digitally transcoded analog video signals. Both inputs support HDCP 2.2.
NOTE:
When an input sends protected content to a non-HDCP compliant monitor, the video output displays a black screen rather
than a red screen as displayed via Enova DVX Presentation Switchers.
Instruction Manual - Incite Digital Video Presentation Systems
HDMI INPUT Connectors - Pinouts and Signals
Pin
Signal
Pin
Signal
1
TMDS Data 2+
11
TMDS Clock Shield
2
TMDS Data 2 Shield
12
TMDS Clock-
3
TMDS Data 2-
13
CEC
4
TMDS Data 1+
14
Reserved, HEC Data
5
TMDS Data 1 Shield
15
SCL
6
TMDS Data 1-
16
SDA
7
TMDS Data 0+
17
DDC/CEC/HEC Ground
8
TMDS Data 0 Shield
18
+5V Power (max 50mA)
9
TMDS Data 0-
19
Hot Plug Detect, HEC Data+
10
TMDS Clock+
DVI Input Adapter Cables
Name
Description
Length
FG#
HDMI Interface
Cable
HDMI Male to HDMI Male
6 1/2’ (2m)
FG10-2178-05
HDMI to DVI Cable
HDMI Male to DVI Male
6’ (1.828m)
FG10-2179
