![background image](http://html.mh-extra.com/html/amx/max-avp/max-avp_operation-reference-manual_2938057054.webp)
MAX-AVP User Interface
48
MAX-AVP Audio-Video Player
PAL M
PAL 60
480p59
576p50
Display Aspect Ratio
: Press
SELECT
to set the aspect ratio for the display device:
Widescreen
= 16 x 9
Standard
= 4 x 3
Digital Audio
: Press
SELECT
to set the format of audio sent via the S/PDIF digital
connection PCM or Bitstream (DD/DTS)). PCM of no decoder is present in the attached
device, Bitstream if a Dolby Digital or DTS decoder is present.
HDMI
: Select whether HDMI should auto-detect the video mode from the display, or be
manually fixed to the specified video standard (
default =
AUTODETECT
).
If HDMI is set to
MANUAL
, the
Video Standard
setting (see above) only selects modes
for HDMI (i.e., the mode selected with
Video Standard
will not influence the analog
outputs).
If HDMI is set to
AUTODETECT
, and the AVP is connected via HDMI, the
Video
Standard
setting is disabled.
Widescreen Formatting
: Select the formatting mode for widescreen content playback on a
standard aspect ratio display.
Pan-and-Scan
: fills the screen
Letterbox
: retains the film’s actual aspect ratio
Some DVDs do not support widescreen formatting, in which case this option has no
effect.
Color Space
: Select the colorspace for the display. The options are:
YUV-601
(Consumer component video –
default
)
Leave the Color Space setting on YUV-601 if you are connecting via composite or
SVideo.
YUV-709
(some professional equipment)
RGB 0-255
(some projectors and monitors)
Screen Saver Timeout (minutes):
Increase/decrease screensaver timeout in increments of 1
minute by selecting the Up or Down arrow and pressing SELECT.
A setting of zero disables the screensaver.
Apply & Save Settings as Default:
Apply the current settings and save them as the default. If
video settings were changed, they will be tested for 10 seconds. Confirm to save, cancel or
wait for timeout to revert to previous settings.
HDMI shuts off the Composite, S-VIdeo and Component outputs.
On exiting the Setup page, the system will prompt you to save any changes, if any
settings have been changed.