ILBLP CP HE SD HV
“S” MOUNTING STYLE
CONSTANT POWER
EMERGENCY LIGHTING EQUIPMENT
FOR LED
(800) 866-4682 • www.iotaengineering.com
INSTRUCTION MANUAL
HIGH EFFICIENCY PERFORMANCE
MEETS CA T20 BATTERY CHARGER
EFFICIENCY STANDARDS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
CAUTION
– The TBTS Test Button Component serves as the unit connector. The
ILBLP CP HE SD HV
will
initiate
once both the TBTS until installation is complete and A.C. power is supplied to the unit.
2.
CAUTION
– This fixture provides more than one power supply output source. To reduce the risk of electrical
shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by discon
-
necting the TBTS Test Button Component before servicing.
3.
CAUTION
– This equipment provides reduced current levels when higher voltage loads are connected. Load
calibration is required to ensure proper operation (see page 4).
4.
CAUTION
– This is a sealed unit. Components are not replaceable. Replace the entire unit when necessary.
5.
CAUTION
– Installation and servicing should be performed by
qualified personnel only
. De-energize before
opening.
6. The
ILBLP CP HE SD HV
is for use with grounded LED luminaires listed to UL standards. Not for use in
heated air outlets or hazardous locations.
7.
The
ILBLP CP HE SD HV
and A.C. driver
must
be on the same branch circuit.
8. Do not mount near gas or electric heaters.
9. The
ILBLP CP HE SD HV
should be mounted in locations and at heights where it will not readily be subjected
to tampering by unauthorized personnel.
10. Product output voltage varies according to wattage. Refer to
Illustration 1
for output voltage per model.
11. The
ILBLP CP HE SD HV
is certified in the CA Title 20 Modernized Appliance Efficiency Database System
(MAEDBS) as a small battery charger.
12. Suitable for use in damp locations.
13. For use in 0° C minimum, 55° C maximum ambient temperatures.
14. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition, void
warranty, and result in non-compliance with UL specifications.
15. Do not use this equipment for other than intended use.
16. Install in accordance with the National Electrical Code and local regulations.
17. Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility before
final installation. See addendum for compatibility and covered luminaire requirements.
SAVE THESE INSTRUCTIONS
