HDMI UTPro WebConsole
76
Instruction Manual – HDMI-UTPRO-0808
Anytime you click Reboot from any page in the WebConsole, the server reboots. The reboot updates information
between the HDMI UTPro and the server. (The HDMI UTPro system itself does not reboot.)
Click
Accept
to save the changes. IP setting changes require a reboot.
Click
Cancel
to exit the page without saving any changes.
Click
Reboot
to initiate a system reboot. IP Settings changes only take effect after a reboot.
Port Settings
Select
Port Settings
from the Admin drop-down menu to open the
Port Settings
page (FIG. 51). Use the options on the
page to specify various Port settings for the HDMI UTPro.
The options on the
Port Settings
page provide inputs for enabling / disabling of HTTP, HTTPS, Telnet, SSH, and FTP
ports, plus allowing you to change each port number from its standard default assignment.
Click
Accept
to save the changes. Port Settings changes require a reboot.
Click
Cancel
to exit the page without saving any changes.
Click
Reboot
to initiate as system reboot. Port Settings changes only take effect after a reboot.
Important:
The Admin menu option “Restore Settings” will restore the factory default settings as listed in the
table above for this page.
IP Settings
DHCP
• Click to toggle the DHCP setting on the HDMI UTPro (default = enabled).
• When the DHCP check box is not selected, a static IP address (with the appropriate
subnet) must be entered.
• When the DHCP check box is not selected, a static IP address (with the appropriate
subnet) must be entered in order for the HDMI UTPro to be detected by a
zeroconfiguration client (e.g., Bonjour for Windows).
• The HDMI UTPro will not display in the NetLinx online tree unless it resides on the
same LAN and subnet as the PC running NetLinx Studio and the NetLinx Master to
which the HDMI UTPro is connected.
See
Accessing Zero-Config Information in NetLinx Studio 3.0
on page 69 for details.
Hostname
Enter a Hostname for the HDMI UTPro.
IP Address
Enter an IP Address for the HDMI UTPro (enabled only if DHCP is disabled).
Subnet Mask
Enter a Subnet Mask for the HDMI UTPro (enabled only if DHCP is disabled).
Gateway
Enter a Gateway for the HDMI UTPro (enabled only if DHCP is disabled).
Domain Suffix
Enter the Domain Suffix for the HDMI UTPro.
DNS 1, 2, 3
Enter up to three DNS addresses for the HDMI UTPro.
FIG. 51
Port Settings page
Port Settings
HTTP Port Number
Default = enabled, default port number = 80
HTTPS Port Number
Default = enabled, default port number = 443
Telnet Port Number
Default = enabled, default port number = 23
SSH Port Number
Default = enabled, default port number = 22
FTP Port Number
Default = enabled, default port number = 21
