AMX AutoPatch Modula, Инструкция по эксплуатации, Страница: 139 / 191

Cat5 Video and Audio Boards with TXs & RXs
133 Modula Instruction Manual
Attaching Cables and Wires
When attaching input and output cables, refer to the sheet labeled “AutoPatch Modula Connector Guide”
that ships with the system. The sheet shows you where to attach the wires and cables on the rear of the
enclosure. Follow the sheet exactly; the system was programmed to operate
only as indicated on the
sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., “Chassis 1 of 3”) on a
label located on the left side (near the power receptacle).
Each Modula Cat5 board has four RJ-45 modular receptacles. Connector options for the TX and RX
Modules and AF-10 boards include BNC, RCA, or S-Video for video and 3-position terminal block
(balanced or unbalanced) or RCA (unbalanced) for audio.
To attach Cat5 (RJ-45) inputs and outputs:
1.
Adjust the Modula Cat5 board for line length if necessary (see page 130).
2.
Insert the RJ-45 cable connectors into the input and output RJ-45 receptacles (FIG. 88).
FIG. 88
Insert RJ-45 connector into RJ-45 receptacle