Installation
14
6" Color Video Touch Panels
5.
Position the strain relief onto the cable with the strain relief located against the heat shrink
tubing (at the base of the tabletop cable split) as shown in FIG. 15 on page 14. The strain relief
should begin clasping after the heat shrink.
6.
Close the strain relief over the designated location.
FIG. 14
Installation of relief/cable combo into the AC-CV6T enclosure
Rear view
Circular front of strain relief
lies flush against enclosure
Strain relief
is mounted on the
edge of the heat shrink
Heat
shrink
CLIP FACING UP
VERIFY THE DIRECTION AND LOCATION OF THE STRAIN RELIEF
.
The clip must be facing UP (on top).
Once closed, it is difficult to re-open. Grooves align against heat shrink and the flat
circular opening faces away from the enclosure. Refer to FIG. 15 for more
information.
FIG. 15
Tabletop cable and strain relief installation
5 inches
(from tip to base)
Strain relief
First
- Thread through
Second
- Position
Third
- Snap closed
cable
10 inches
RELIEF GROOVES GO INTO ENCLOSURE
FLAT SURFACE POINTS AWAY FROM ENCLOSURE
total
Verify the relief is securely closed over the cable and facing the correct
direction. The process of securing the strain relief might require the use of
pliers.
