DM756 User Guide
DM756 User Guide
Page 14
Using Support Systems
The DM756 is designed for use with a variety of support systems, including those typically used with stereo microscopes
such as table stands, boom-arm stands, and articulating stands. Due to the DM756’s high magnifications, it is recom
-
mended to always use a support to avoid shaking which will result in poor-quality images.
This microscope uses a 50mm mounting diameter which requires a specific collar or adapter. Support systems which use
50mm collars can be used with the DM756 without any adapters. Support systems using 76mm collars can be used in
conjunction with the AD-SZ76 adapter.
Mounting to a 50mm Collar
To mount the microscope to a 50mm collar, first ensure that no accessories are attached which would cause obstruction,
such as ring lights. Next, loosen any locking screws on the collar. With the microscope’s lens pointed down, gently slide
the instrument into the collar. The collar should align with a groove on the microscope located above the zoom dial, at
which point the microscope should be properly seated, and unable to be lowered any further. Rotation of the microscope
can verify that it is properly seated. Align the logo on the microscope with the front of the collar, then tighten any locking
screws enough to prevent further rotation.
Mounting to a 76mm Collar
To mount the microscope to a 76mm collar, the AD-SZ76 adapter must be attached to the microscope. Begin by visually
inspecting the inner surface of the adapter to ensure that the securing screws are not protruding, as they can obstruct or
scratch the microscope. A 2mm hex wrench can be used to loosen the screws if necessary. Next, with the microscope’s
lens pointed up, gently slide the adapter with the lip facing downward onto the microscope until it is properly seated.
The adapter should have two or three securing screws pre-mounted. These screws prevent the microscope from rotating.
Use a 2mm hex wrench to tighten these screws, being careful not to overtighten them. Once the adapter is secure, turn
the microscope so the lens is pointing downward, then lower the microscope into the collar of the support system until
the adapter’s lip is flush with the collar.
