AMS Neve 88D, Руководство пользователя

Страница: 11 / 85

88D User Manual
11
3.b Fader Assignment
88D makes economical use of the fader strips by having up to 24 pages grouped
together in 6 banks, each comprising of 4 layers.
The layout of the paths in the layers and banks is performed using Desk Designer,
which is accessed in Desk Editor (see Encore Plus Manual).
The paths that are currently active on the faders are said to be "on the surface".
Layer Selection on The Fader Strips
The Required Bank is selected by pressing the numbered keys on the touch screen
when in banks mode (banks mode is selected by pressing the banks key next to the
layer name alphas)
The required bank can also be selected by holding the bank key and pressing the ‘+’
or ‘-‘ key above it on the Master Panel and the required layer within that bank is
selected using the A, B, SUB A or SUB B global layer selection keys. By default,
selecting a bank will bring layer A to the surface. It is also possible to scroll through
the banks, using the left and right arrow keys under the Bank Select keys.
To assign a particular layer to the assignable logicators, call the required bank to the
surface, then use the Logicator Layer Selection keys.
Assigning signal paths to faders within layers and banks can be done within Encore
Plus. The required bank should be selected in Desk Designer, then the four layers
within that bank set up. Another bank can be selected and the layers set up in the
same the first bank was. When the set up is complete, clicking on Save+Load will
apply these changes.
Fader Calibration
The faders are calibrated when the console is started up, either from a cold start or a
re-boot.
A fader calibration can be performed manually. To calibrate the faders press and
hold the clear key . Press the fader key by the monitoring section , then release both
keys. The faders will be re-calibrated. Audio is not affected by fader calibration (i.e.
the console is not muted).