PII-3100 MAINBOARD MANUAL
13
CHIPSET FEA
TURES SETUP
EDO CASX# MA WAIT STATE
The default value is 1
EDO RASX# WAIT STATE
The default value is 1
SDRAM CAS LATENCY TIME
Set on 3
For 67 / 83 MHz SDRAM DIMM module.
Set on 2
For 100 MHz SDRAM DIMM module.
Set on Auto
CAS latency time will be set automatically if you have SPD
DRAM DATA INTEGRITY MODE
Set on Non-ECC For 64bit standard type DIMM module.
Set on ECC
For 72bit ECC type DIMM module.
SYSTEM BIOS CACHEABLE
The default value is Enabled.
VIDEO BIOS CACHEABLE
The default value is Enabled.
VIDEO RAM CACHEABLE
You can enable this function to get better VGA performance. However for some brands
of VGA cards this must be disabled (e.g.ET4000W32P).
16 BIT I/O RECOVERY TIME
Set 16 Bit I/O recovery time from 1 to 4 or NA for none.
MEMORY HOLE AT 15M-16M
Set on Enabled to Set Address = 15-16MB remap to ISA BUS.
DELAYED TRANSACTION
Set to Enabled for certain slow speed ISA devices in your system.
CLOCK SPREAD SPECTRUM
The default value is Disabled.
SLOW DOWN CPU DUTY CYCLE
You can set the Slow Down CPU Duty Cycle to 12.5%, 25.5%, 37.5%, 50.0%, 62.5%
or 75% do these functions required special HW or SW.
ALARM WHEN CPU OVERHEAT
Set to Enabled when you want an Alarm when the CPU temperature exceeds the limit.
CPU TEMPERATURE SELECT
The default value is 75°C / 167°F. If exceeded the system will alarm & slow down CPU
speed.
CPUFAN CONTROL
When Enabled the system will check the CPUFAN status.
CURRENT CPU TEMPERATURE / FAN SPEED / VOLTAGE STATUS
You can set it to Detect these settings automatically.
CURRENT BATTERY LIFE
The default value depends on system monitoring Battery status.
