Ampt 31570013, Руководство по установке

Страница: 14 / 22

14
Installing the Ethernet Cable Feed ‐ through
A liquid-tight wire grip is recommended for the Ethernet cable feed-through. The markings on
the bottom of the unit show where to make a hole for the wire grip.
Figure 4: Bottom view of the communication unit
1. Make sure the communication unit is not powered up.
2. Use a drill or punch to create a hole for the wire grip within the marked area.
Notice:
Drilling outside of the designated area may damage internal electronic
components.
Figure 5: Drill hole for the wire grip within the marked area
Install liquid ‐ tight
wire grip in this area