ESD Caution
Connections to other pieces of equipment are made at the rear of the Horizon imager. These
connectors are marked with a precautionary ESD warning symbol, as shown below. Do not touch
any of the pins of these connectors. When making connections to the imager, it is best done while
the imager is plugged in but not powered on. ESD may cause erratic behavior of the imager when
powered on. Should this occur, power to the imager may have to be cycled. It is recommended that
all staff involved in making connections to the imager be aware of these ESD precautions.
Potential for Radio Frequency Interference on Imager Operation
Both portable and mobile RF communications equipment can affect medical electrical equipment,
including the Horizon imager. Keep such RF communications equipment out of the immediate
area.
Potential for Radio and Television Interference
The Horizon imager generates and uses radio frequency energy, and if not installed and used
properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference
to radio and television reception. It has been type tested and found to comply with Class B emission
limits for a computing device in accordance with the specifications in Subpart J of Part 15 of FCC
Rules, which are designed to provide reasonable protection against such interference when
operating in a commercial environment. Operation of the equipment in a residential area is likely to
cause interference, in which case the user, at his own expense, will be required to take whatever
measures may be appropriate to correct the interference. If your imager does cause interference to
radio or television reception, you are encouraged to try to correct the interference by one or more of
the following measures:
