8
Setup Mode
Press the “
SET[ ]
” button in normal mode to switch to
setup mode, the indicator “
SET
” is shown on the left
side of the display. To switch back to normal mode, press
“
SET[ ]
” button.
Wireless Mode
Press the “ ” key for more than two seconds to start
wireless function. Press the “ ” key again for another
two seconds to stop wireless function. The wireless mode
will shut down if there is no wireless signal for two
minutes.
To SET CH/ID to 00,00, by pressing “
T1-T2
” key and “
” power key for more than 6 seconds with the meter
powered down. The meter will set channel and ID to
00,00 status. The second display will show 00, which
means that the channel and ID has been set to 00.
To check the channel and ID of the meter
When the meter is off press “
” key and “ ” for 5
seconds, LCD’s main display will show channel number,
the second display will show ID number.
Normal Mode
The following functions can only be used in the normal
mode.
“ ” Power Button
The “ ” key turns the thermometer on or off. When
enter data REC mode, the power off function is disabled.
“[LIMITS]” Button (only Main display)
The limits function will alert the user when a
measurement exceeds a specified limit. To set the limit
values, refer to limits function in the setup mode. Press
the “
[LIMITS]
” button to activate the limits function; the
word “
LIMIT
” should be displayed on the LCD.
